IPC64/19(M)-WM FRONT CONNECTORS
The IPC64/19(M)-WM serial ports COM1 and COM2 are 9-pin male SUB-D connectors with standard PC pinouts. Both serial ports are using RS232C interface levels. The ports are fully compatible with the 16C450 (CP/386EX Single Board Computer) or 16C550 ACE registers (CP/486DX1 Single Board Computer). This offers software compatibility with PC type driver programs. The serial ports are mapped at COM1 I/O adr. 3F8h - 3FFh with IRQ4 and COM2 I/O adr. 2F8h - 2FFh and interrupt request line IRQ3.
| IPC64/19(M)-WM COM1 / COM2 Pinout | |||
|---|---|---|---|
| Pin | Name | Function | Direction |
| 1 | DCD | Data Carrier Detect | IN |
| 2 | RxD | Receive Data | IN |
| 3 | TxD | Transmit Data | OUT |
| 4 | DTR | Data Terminal Ready | OUT |
| 5 | GND | Signal Ground | --- |
| 6 | DSR | Data Set Ready | IN |
| 7 | RTS | Request to Send | OUT |
| 8 | CTS | Clear to Send | IN |
| 9 | RI | Ring Indicator | IN |
The IPC64/19(M)-WM parallel printer port LPT1 is a 25-pin female SUB-D connector with standard PC pinout. This parallel printer port has the drive capability of a bidirectional Centronics port (EPP features) if the CP/486DX1 Single Board Computer is used within the IPC64/19(M)-WM. The IPC64/19(M)-WM with the CP/386EX Single Board Computer offers only the SPP features.
| IPC64/19(M)-WM LPT1 Pinout | |||
|---|---|---|---|
| Pin | Function | EPP Direction | SPP Direction |
| 1 | Strobe | I/O | OUT |
| 2 | Data Bit 0 | I/O | OUT |
| 3 | Data Bit 1 | I/O | OUT |
| 4 | Data Bit 2 | I/O | OUT |
| 5 | Data Bit 3 | I/O | OUT |
| 6 | Data Bit 4 | I/O | OUT |
| 7 | Data Bit 5 | I/O | OUT |
| 8 | Data Bit 6 | I/O | OUT |
| 9 | Data Bit 7 | I/O | OUT |
| 10 | Acknowledge | IN | IN |
| 11 | Busy | IN | IN |
| 12 | Paper End | IN | IN |
| 13 | Select | IN | IN |
| 14 | Autofeed | OUT | OUT |
| 15 | Error | IN | IN |
| 16 | Init. Printer | OUT | OUT |
| 17 | Select Input | OUT | OUT |
| 18 - 25 | Signal Ground | --- | --- |
For file download and upload between the IPC64/19(M)-WM and your Windows 95 or Windows 98 based desktop PC, please use the good old MS-DOS programs INTERSVR and INTERLNK together with a LabLink III interface cable. Connect this cable with the IPC64/19(M)-WM LPT1 port and the LPT port of your desktop computer.