SSV - IPC64/19 FPPC

IPC64/19 MS-DOS STARTER KIT - POWER SUPPLY

The SSV IPC64/19 Flat Panel PC only requires +5 VDC. The power is brought into the BB2 Base Board via an 7- pin power connector (J9 - Power). Each IPC64/19 MS-DOS Starter Kit contains a power cable for the BB2 Base Board 7- pin power connector J9 with a 7- pin female DIN connector on the other end and a 110 - 230 VAC input / 5 VDC output power supply (ordercode PWR1-3219). This power supply offers a 7- pin male DIN connector.

Attention: The keyboard I/F cable and the power cable of the IPC64/19 MS-DOS Starter Kit are very similar. Please note the differences. The power cable offers a 7- pin female DIN connector on one end, the keyboard I/F cable only a 5- pin female DIN Connector.

7-pin DIN Connector Pinout
Pin	Function	Used
1	+5 VDC	BB2 Base Board, CP/486DX1 Single Board Computer
2	+12 VDC	BB2 PC/104 Connector
3	GND	Ground
4	-12 VDC	BB2 PC/104 Connector
5	-5 VDC	BB2 PC/104 Connector
6	+5 VDC	BB2 Base Board, CP/486DX1 Single Board Computer
7	GND	Ground

Please note: The IPC64/19 with the BB2 Base Board and the CP/486DX1 Single Board Computer (SBC) needs only +5 VDC for operation. The Starter Kit power supply with the ordercode PWR1-3219 offers only +5 VDC. The pins for +12 VDC, -12 VDC, and -5 VDC are connected with the BB2 PC/104 connector. If you are using PC/104 boards within the IPC64/19, which needs other voltages then +5 VDC, please use a other power supply.

BB2 Base Board Connector J9 - POWER IN Pinout
Pin	Function	Used
1	GND	Ground
2	GND	Ground
3	-5 VDC	BB2 PC/104 Connector
4	+12 VDC	BB2 PC/104 Connector
5	-12 VDC	BB2 PC/104 Connector
6	+5 VDC	BB2 Base Board, CP/486DX1 Single Board Computer
7	+5 VDC	BB2 Base Board, CP/486DX1 Single Board Computer

| Home Page | IPC64/19 |